VANCOUVER, BC / ACCESSWIRE / February 7, 2024 / Gold Terra Resource Corp. (TSX-V:YGT)(Frankfurt:TX0)(OTCQX:YGTFF) ("Gold Terra" or the "Company") announces the start of a second deep drill hole to continue establishing the extension of high-grade gold mineralization in the Campbell Shear (CS) below the Con Mine underground workings on the Con Mine Option (CMO). The CMO Property is under option from subsidiaries of Newmont Corporation and is 100% acquirable by the Company upon fulfillment of certain conditions set out in the CMO Property agreement, as reported in the Company's news release dated November 22, 2021.
Deep Drilling Update
Our first deep drill hole, GTCM23-055, was a success in confirming gold mineralization 200 metres below existing underground workings and extending the CS with a typical gold intersection of 12.73 g/t Au over 1.7 metres. While the drilling operator was completing a lateral wedge from this master hole targeting the CS some 75 metres north of the first intersection, the drilling operator made a mistake with setting up a second wedge, and the hole had to be abandoned. As a result, it was decided to start a second deeper hole approximately 600 metres below the Robertson shaft (1,900 metres below surface), to test a larger area for gold mineralization in the CS as shown in Figure 1 below. The second deep drill hole is estimated to intersect the CS, some 600 metres below the underground workings, which will allow the company a bigger area to add multiple wedges, and intersections of the CS.
Chairman and CEO, Gerald Panneton, commented, "After successfully confirming the extension of the high-grade Campbell Shear zone 200 metres vertically below the Robertson shaft with hole GTCM23-055, we are moving the drill to a new location for a second deep hole. We look forward to completing another successful deep drill hole to intersect both the Con Shear which produced 1 Moz @ 20 g/t Au as well as our primary target, the Campbell Shear (CS) which produced 5.1 million ounces of gold at an average grade of 16 g/t from the Con Mine."
Figure 1 - Section showing Campbell Shear intersection: (section is looking approx. north)
Qualified Persons
Joe Campbell, P. Geo., Senior Technical Advisor for Gold Terra is a Qualified Person within the meaning of NI 43-101 and has reviewed and approved the technical information contained in this news release.
About Gold Terra
The Yellowknife Project (YP) encompasses 918 sq. km of contiguous land immediately north, south and east of the City of Yellowknife in the Northwest Territories. Through a series of acquisitions, Gold Terra controls one of the six major high-grade gold camps in Canada. Being within 10 kilometres of the City of Yellowknife, the YP is close to vital infrastructure, including all-season roads, air transportation, service providers, hydro-electric power, and skilled tradespeople. Gold Terra is currently focusing its drilling on the prolific Campbell Shear, where approximately 14 Moz of gold has been produced, (refer to Gold Terra Oct 21, 2022, Technical Report) and most recently on the Con Mine Option (CMO) property claims immediately south of the past producing Con Mine which produced 6.1 Moz between the Con, Rycon, and Campbell shear structures (1938-2003).
The YP and CMO properties lie on the prolific Yellowknife greenstone belt, covering nearly 70 kilometres of strike length along the main mineralized shear system that hosts the former-producing high-grade Con and Giant gold mines. The Company's exploration programs have successfully identified significant zones of gold mineralization and multiple targets that remain to be tested which reinforces the Company's objective of re-establishing Yellowknife as one of the premier gold mining districts in Canada.
Visit our website at www.goldterracorp.com.
For more information, please contact:
Gerald Panneton, Chairman & CEO
gpanneton@goldterracorp.com
Mara Strazdins, Investor Relations
Phone: 1-778-897-1590 | 604-689-1749 ext 102
strazdins@goldterracorp.com
Neither the TSX Venture Exchange nor its Regulation Services Provider (as that term is defined in the policies of the TSX Venture Exchange) accepts responsibility for the adequacy or accuracy of this release.
Information Concerning Estimates of Mineral Resources
Mineral Resources that are not Mineral Reserves do not have demonstrated economic viability. Therefore, investors are cautioned not to assume that all or any part of an Inferred Mineral Resource could ever be mined economically. It cannot be assumed that all or any part of "Measured Mineral Resources," "Indicated Mineral Resources," or "Inferred Mineral Resources" will ever be upgraded to a higher category. The Mineral Resource estimates contained herein may be subject to legal, political, environmental or other risks that could materially affect the potential development of such mineral resources. Refer to the Technical Report, once filed, for more information with respect to the key assumptions, parameters, methods and risks of determination associated with the foregoing.
Cautionary Note to United States Investors
The Company prepares its disclosure in accordance with the requirements of securities laws in effect in Canada, which differ from the requirements of U.S. securities laws. Terms relating to Mineral Resources in this news release are defined in accordance with NI 43-101 under the guidelines set out in CIM Definition Standards on Mineral Resources and Mineral Reserves, adopted by the Canadian Institute of Mining, Metallurgy and Petroleum Council on May 19, 2014, as amended ("CIM Standards"). The U.S. Securities and Exchange Commission (the "SEC") has adopted amendments effective February 25, 2019 (the "SEC Modernization Rules") to its disclosure rules to modernize the mineral property disclosure requirements for issuers whose securities are registered with the SEC under the U.S. Securities Exchange Act of 1934. As a result of the adoption of the SEC Modernization Rules, the SEC will now recognize estimates of "Measured Mineral Resources", "Indicated Mineral Resources" and "Inferred Mineral Resources", which are defined in substantially similar terms to the corresponding CIM Standards. In addition, the SEC has amended its definitions of "Proven Mineral Reserves" and "Probable Mineral Reserves" to be substantially similar to the corresponding CIM Standards.
U.S. investors are cautioned that while the foregoing terms are "substantially similar" to corresponding definitions under the CIM Standards, there are differences in the definitions under the SEC Modernization Rules and the CIM Standards. Accordingly, there is no assurance any Mineral Resources that the Company may report as "Measured Mineral Resources", "Indicated Mineral Resources" and "Inferred Mineral Resources" under NI 43-101 would be the same had the Company prepared the Mineral Resource estimates under the standards adopted under the SEC Modernization Rules. In accordance with Canadian securities laws, estimates of "Inferred Mineral Resources" cannot form the basis of feasibility or other economic studies, except in limited circumstances where permitted under NI 43-101.
Cautionary Note Regarding Forward-Looking Information
Certain statements made and information contained in this news release constitute "forward-looking information" within the meaning of applicable securities legislation ("forward-looking information"). Generally, this forward-looking information can, but not always, be identified by use of forward-looking terminology such as "plans", "expects" or "does not expect", "is expected", "budget", "scheduled", "estimates", "forecasts", "intends", "anticipates" or "does not anticipate", or "believes", or variations of such words and phrases or statements that certain actions, events, conditions or results "will", "may", "could", "would", "might" or "will be taken", "occur" or "be achieved" or the negative connotations thereof.
All statements other than statements of historical fact may be forward-looking information. Forward-looking information is necessarily based on estimates and assumptions that are inherently subject to known and unknown risks, uncertainties and other factors that may cause the actual results, level of activity, performance or achievements of the Company to be materially different from those expressed or implied by such forward-looking information. In particular, this news release contains forward-looking information regarding the current drilling on the Campbell Shear, potentially adding ounces to the Company's current YCG mineral resource, and the Company's objective of re-establishing Yellowknife as one of the premier gold mining districts in Canada.
There can be no assurance that such statements will prove to be accurate, as the Company's actual results and future events could differ materially from those anticipated in this forward-looking information as a result of the factors discussed in the "Risk Factors" section in the Company's most recent MD&A and annual information form available under the Company's profile at www.sedar.com.
Although the Company has attempted to identify important factors that would cause actual results to differ materially from those contained in forward-looking information, there may be other factors that cause results not to be as anticipated, estimated or intended. The forward-looking information contained in this news release is based on information available to the Company as of the date of this news release. There can be no assurance that such statements will prove to be accurate, as actual results and future events could differ materially from those anticipated in such statements. All of the forward-looking information contained in this news release is qualified by these cautionary statements. Readers are cautioned not to place undue reliance on forward-looking information due to the inherent uncertainty thereof. Except as required under applicable securities legislation and regulations applicable to the Company, the Company does not intend, and does not assume any obligation, to update this forward-looking information.
SOURCE: Gold Terra Resource Corp
View the original press release on accesswire.com
